null
Rotometals.com

Sealer Premium Spray Ever Clear for Zinc and Metal Countertops - For Horizontal Surfaces

(1 review) Write a Review
SKU:
everclearspray
MPN:
547856
Availability:
in stock
Weight:
2.00 LBS
Shipping:
Calculated at Checkout
$54.95

Description


Ever Clear is a clear, air-drying, two part lacquer designed to provide the best and strongest protection for most surfaces and finishes. Use Ever Clear on your toughest jobs including counter tops, fountains, ocean environments, etc. It works extremely well on all metals, wood, terracotta, ceramics, and concrete. Ever Clear provides unusually strong under-film tarnish protection, superior resistance to UV light, and remarkable resistance in salty air environments. Sculpt Nouveau's Ever Clear makes an excellent coating to seal and preserve various oxidizing and coloring processes that are used for antique patina and decorative surface treatments. One can of Ever Clear spray will cover 12 square feet with two coats of sealer.


MUST SHIP GROUND - LOWER 48 only - No Air Shipping

DIRECTIONS FOR USE:
 
DO NOT USE INSIDE AS THE SPRAY CAN SPREAD THROUGHOUT THE HOUSE

Make sure the surface is completely dry and dust free before applying Ever Clear. After following directions for activating spray can, press spray button firmly, with the can 10 inches from surface being coated. Move can with short dusting strokes, releasing button at the end of each stroke, applying several thin coats. The second coat should be applied in about an hour. (If you are unable to apply the second coat in a timely manner, you may lightly sand the first coat, so that the second coat will adhere). Take measures to minimize dust and debris falling on your coated products. Metal surfaces should be room temperature (70-85F). Do not use when the temperature is over 85 F or under 50F. After activating the can, use within 6 hours.

Do not use after this amount of time.

DRYING TIME: The coating air dries to the touch in less than 1 hour depending on room temperature and may be forced dried faster at 250F. The coating air dries solid/hard film within 4 hours, depending on coating thickness, temperature, etc. Full cure dry time will be 5 to 7 days.

1) Shake the can well for 2 minutes before activating.
2) Remove the red push button from the cap.
3) Turn can 180 and put the push button on the pin in the can bottom.
4) Place can with the cap upside down onto a stable base.
5) Press the red trigger button with the ball of your thumb until the limit.
6) After activating, shake can well for 2 minutes once again.

 
View AllClose

1 Review

  • 5
    everclear

    Posted by metalexsf on Dec 16th 2020

    I only do patinas on metal for a living. I have to purchased every Polish to Every clear coat yearly. Make sure California did not take out any of the fun stuff. A finish is not finish, with out the last layer. Hands down ever clear is the best. When u mess up , you can just let it cure over night. Take your sander of choice and dust panel with 600 grit. This lets you fix any hiccups ,then pretty much , spary a light layer of ever clear over. If you can't spend the cash on another can, just spary with clear gaurd. My only warning is that their MATT is very very very matt. Also in theses cold times , set your cans in a half filled bucket of hot water. This prevents Andy accidental spitting for those that don't shake for the time suggested. You know who you are hahahaha

View AllClose